|
Controller Unit Specifications
|
CAUTION:
|
If the equipment is
powered on and off repeatedly, the circuit protection may disable
the Axis Unit due to the in-rush current overload. If this is the
case, power down the axis unit for five minutes, before powering
back up. |
|
AXIS UNIT TYPE |
AXIS-203 |
AXIS-205 |
AXIS-210 |
|
TOOL MOTOR TYPE |
M1 |
W1 |
M2 |
M3 |
W3 |
M4 |
|
TOOL MOTOR MODEL NUMBER |
MFA006
HA2NSA |
BNE006-
A117 |
MFA010
HA2NSA |
MFA020
HA2NSA |
BXE020-
A912 |
MFA040
HA1NS |
|
TOOL MOTOR RATING |
60W |
70W |
100W |
200W |
200W |
400W |
|
AXIS UNIT PEAK CURRENT |
.625A |
.625A |
1A |
2A |
2A |
4A |
|
AXIS UNIT IN-RUSH CURRENT |
50A |
50A |
50A |
70A |
70A |
100A |
|
AXIS UNIT INPUT POWER |
200~230 VAC,
3-phase, 50/60 Hz |
Tool model designation includes the motor
type, i.e. model DT-401M2-S has an M2 type
tool and must be used with a Type 203 Axis Unit.
M1 and W1 are functionally identical
motors and can be interchanged without any special consideration. Same
condition is valid for M3 and W3 motors.
|
