|
1.
|
How do I fix an Axis Unit that the
display has gone blank during power up?
|
|
ANSWER |
| 2. |
What causes an encoder fault
(Axis Unit
display codes "A5, d0, d2, d7") and what
can I do to prevent it from happening? |
|
ANSWER |
| 3. |
What causes a Servo Alarm fault
(Axis Unit
display codes "d0, d1, d3, d7") and what
can I do to prevent it from happening? |
|
ANSWER |
| 4. |
Why am I getting a 'sub command error'
displayed on the CRT? |
|
ANSWER |
| 5. |
What is a 'Communication I/F error'
and how do I fix it?
|
|
ANSWER |
| 6. |
No fastening results (from the FASTENING
DATA screen) are being displayed on my monitor, why?
|
|
ANSWER |
| 7. |
What causes a 'preset data abnormal'
error (Axis Unit
display code "a9") ?
|
|
ANSWER |
| 8. |
Why is my system breaking bolts? |
|
ANSWER |
| 9. |
Why am I getting a tool/servo mismatch
error? (Axis
Unit display code "a3")
|
|
ANSWER |
If your question or problem is not listed
here, please
contact our support department via email,
contact form or call (586)
781-2100 |
